Last Modified: 11-29-2007 1.6 A
Service Category: Vehicle Interior Section: Supplemental Restraint Systems
Model Year: 2008 Model: Sequoia Doc ID: RM000002Y2F009X
Title: SUPPLEMENTAL RESTRAINT SYSTEMS: CURTAIN SHIELD AIRBAG ASSEMBLY: INSTALLATION (2008 Sequoia)

INSTALLATION

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

(a) Engage the 11 claws and 2 clamps and install the curtain shield airbag.



(b) Install the 14 bolts.

Torque: 11 N·m (110 kgf·cm, 8 ft·lbf)

NOTICE:

Do not twist the curtain shield airbag when installing it.

(c) Connect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL ROOF HEADLINING ASSEMBLY

(a) Refer to the procedures from "Install Roof Headlining Assembly" INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 Sequoia) .

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 Sequoia) .

Torque: 5.4 N·m (55 kgf·cm, 48 in·lbf)

4. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: DIAGNOSIS SYSTEM (2008 Sequoia) .